Home > PRODUCT > Eelevater Door

PRODUCT

Eelevater Door

PRODUCT

Korea House Is Beautifil And Comfortable

Overview Summary

Ms series elevator door control, vector control drive, supplies accurate torque-control and speed-control with feed back control of the rotor's position from encoder.
The exclusive program for the elevator door control of micro processor can control door moving pattem suitable for use's requests.
Features
  • Fast response : accurate speed control with no slip. torque control with fast response.
  • Various torque control : 100% stalling torque, 300% starting torque.
  • Separated input function between main controller and sensor signal.
  • Speed control with 1:3000 resolutin.
  • Sinusoidal digital vector control.
  • Protection of immediate power failure for max 500m/sec.
  • Protection of open circuits and short circuits.

  • Apply to Motor :

    1. Induction
    2. PM (Servo motor)
    3. IPM (IMPM)

    • Specification
    MS 400 MS 200 MS 100 MS 800 MS 2200
    Input voltage 1AC 200 / 220V +- 15%
    Input frequency 47 - 63HZ
    Output capacity 400W (1/2Hp) 200W (1/4Hp) 100W (1/8Hp) 800W (1Hp) 2.2kw (3Hp)
    Rated output current 1.9A 1.3A 0.8A 3.3A 8.2A
    Max. output current 7A 5A 3A 10A 25A
    Max. overload accommodation capability 300% of rated current for one second/
    250% of rated current for one second/
    200% of rated current for one second/
    150% of rated current for one second
    Operation temperature -10℃ ~ +45℃
    Relative humidity 90% non-condensation
    Installation height over the sea level within 1000m
    System abnormality treating function encoder pulse signal abnormal input, circuit board abnormality, and excessive noise input
    protecting function insufficient voltage, over voltage, overload, short, and ground short
    External diagram
    Open Close Pattern and Parameters (sample)
    System Parameter (sample)
    PAR. FUNCTION
    P00 Operating display
    P01 Operating soft start time [msec]
    P02 Operating soft start speed [mm/sec]
    P03 Open accel. [**]
    P04 Open high speed [mm/sec]
    P05 Open decel. [**]
    P06 Open creeping distance[mm]
    P07 Open creeping speed[mm/sec]
    P08 OLS on stop Decel. [**]
    P09 Open torque [%]
    P10 [%]
    P11 Close Accel.[**]
    P12 Close high speed [mm/sec]
    P13 Close high Decle.[**]
    P14 Close creeping distance[mm]
    P15 Close creeping speed[mm/sec]
    PAR. FUNCTION
    P16 CLS on running time
    P17 CLS on running speed
    P018 Close torque
    P19 Nudging close high speed
    P20 Open/close stop Decel
    P21 Reopen Accel.
    P22 jog speed
    P30 Door stroke
    Per revolution of door motor [mm]
    P31 Auto calibration
    (1:auto calibration)
    P32 Door stroke [mm]
    [read-only parameter]
    P33 Data initial
    (1:auto to factory default values)[%]
    P34 Display mode(0=input, 1=pulse, 2= rpm)

    [**]Accel & Decle. (Large value means that door speed changes rapidly)

    ** To reser the micro-process system, power should be turned off for more than 20 sec.